Dependable metal roof installation for Aurora homeowners from Roofing Brothers — measured on site, done on schedule, and cleaned up after.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Aurora install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Roofing Brothers has been doing metal roof installation since 2002, first around Morganton, North Carolina and now for Aurora homeowners through our network of local crews. The standard has not moved: measure it right, fasten it right, and never cut a corner where water can find it.
Before any metal roof installation starts in Aurora you will know the price, the material and the schedule. Estimates are always free, and nobody is going to push you to decide while somebody is still standing in your driveway.
How a job actually runs, from the first phone call to the last magnet pass over the driveway.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
Questions homeowners ask us about this kind of work.
Much less than people expect. Over solid decking with underlayment, a Aurora metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Installed properly over sound decking, a metal roof should give a Aurora home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Aurora homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Sometimes. If the decking is sound and there is only one layer of shingles, a Aurora metal roof can go over the top on purlins. Two layers or rot underneath and we tear off first — and we say so before you sign.
What people said once the job was finished and the trucks were gone.
"Called about shingles that blew off in a storm. They were out the next morning, patched it, and would not take a dime more than what the estimate said."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They roofed our addition and tied in the porch that runs off it. One crew, one number to call, and every line of it matched up."